![]() ![]() In main routine there is no modbus blocks, but at start-up com init and modbus config. If I connect usb cable to PLC and having connected com1 to plc and servo it works as well. With NetBIOS over TCP/IP or NBT for short the following ports are used: NetBIOS name, UDP. On the other hand when i disconnect com1 from PLCside or servo side then pressing button (MB113) makes output O0 active. Standardizing name resolution on DNS for file and printer sharing. I started searching what is going on and checked that this happens when com1 is connected to servo but usb cable I use to programm is disconnected from the PC computer. Watching this online I see I press the button (MB113 makes active-red color) but output remains still off. Open a Terminal and type: sudo apt-get update sudo apt-get upgrade sudo apt-get install samba samba-common-bin. We’re going to update our repository index, make sure our operating system is fully updated, and install Samba using apt-get. If button pressed (let's say MB 113) then open (O 0)įor a connection I use com1 as a RS232. Samba is available in Raspbian’s standard software repositories. In manual mode there is simply (as a subroutine): Yes, thats the whole point Thats why he - and everybody else - wants a SMB solution, but - unless rooted - Android can not use ports below 1024. The PLC controller in automatic mode connects with servo and sends datas via modbus (that works). If you wish to run Samba on your firewall and access shares between the firewall and local. In start-up display one can choose which mode. This method works well for linux, because both smbclient and smbmount has an option to set server port. I tried letting the samba daemon listen on a non-standard port. So all samba shares dont work outside the LAN. one for automatic mode and one for manual mode. The firewall on my network drops all packets on TCP port 139 and 445. Add the -p option to the end of your options to the container, or set the PERMISSIONS environment variable. ![]() Having startup display and two additional displays. How do I open the port to be able to connect to my Samba server If running FirewallD, it is. I'm new on this forum so i'd like to say welcome at first. I cannot reach my Samba server after starting the service. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |